Daily Quiz 55

Daily Quiz 55

WRD Quiz, SSC JE Quiz, RRB Quiz, Rajasthan JE Quiz, Civil Engineering  MCQ, Mahpariksha Civil Engineering  Objectives, JE Questions civil engineering

This Daily Quizzes is made up for daily practicing objective type questions both technical as well as non technical. In this Quizzes Questions are added from previous year question papers such as Mahapariksha PWD, Mahapariksha Town planning, Mahapariksha Soil and Water Conservation Department, WRD, Rajasthan JE, ITI Lecturer, SSC, RRB, BMC, GATE, ISRO, MPSC, UPSC, APPSC, Metro and also from objectives types books . I hope this is helpful for your upcoming Exams ✌.

All the best for your all upcoming Exams 👍💐💐💐

👉  👈

👉  👈

👉  👈

👉  👈

WRD Quiz, SSC JE Quiz, RRB Quiz, Rajasthan JE Quiz, Civil Engineering  MCQ, Mahpariksha Civil Engineering  Objectives, JE Questions civil engineering

Daily Quiz

Q.1. For a sand deposit, the void ratio was determined at the loosest, densest, and natural states as 0.7, 0.3, and 0.5 respectively. The relative density of the sand deposit is:  [COAL India : 2020]

a) 75%

b) 50% ✔

c) 60%

d) 25%

Q.2. The standard penetration test (SPT) conducted on fine sand below the water tablegave the average blow count as 33. What is the corrected SPT value? [COAL India : 2020]

a) 29

b) 21.5

c) 26.5

d) 24 ✔

The corrected penetration number, NC

NC = 15 + 0.5 (NR -15) = 15 + 0.5 (33 -15) = 24

Q.3. In which of the following, kerosene oil is used for its preparation ?

a) Emulsion

b) Slow curing cutback

c) Medium curing cutback ✔

d) Rapid curing cutback

Slow curing cutback - HIGH BOLILING POINT DILUENT

Medium curing cutback - KEROSENE

Rapid curing cutback - NAPTHA / GASOLINE

Q.4. In the design of purlins, depth of angle section should not be less than:

a) L/ 45 ✔

b) L/ 60

c) L/ 50

d) No relationship

Q.5. In a CBR test, If the CBR value at 5 mm is greater than that at 2.5 mm:

a) The higher value should be chosen

b) The test should be repeated ✔

c) Average value of the two should be used

d) None of these

Q.6. If levelling staff is held inclined at a staff station, the reduced level calculated from observation would be:

a) True R.L.

b) More than true R. L.

c) Less than true R. L. ✔

d) Equal to R. L. of Bench mark

Q.7. Which IS code is used for classification of timber for seasoning purposes ? [ESE : 2014, JPPSC : 2019]

a) IS : 1141-1958 ✔

b) IS : 1708-1969

c) IS : 4970-1973

d) IS : 399-1963

IS: 1141-1958- Classification of timber for seasoning purposes
IS: 1708-1969-Methods of testing of small specimen of timber
IS: 4970-1973-Key for Identification of commercial timbers
IS: 399-1963- Classification of commercial timbers and their zonal distribution

Other important IS Codes

Q.8. In which pollution zone of the river, the dissolved oxygen reduced to zero ? 

a) Zone of degradation

b) Zone of recovery

c) Zone of clean water

d) Zone of active decomposition ✔

Q.9. The optimistic, most likely and pessimistic estimates of time for an activity are 4 days, 11 days and 12 days respectively. The expected completion time of this activity is

a) 10 days ✔

b) 11 days

c) 9 days 

d) 5 days

Q.10. A welded steel plate girder consisting of two flange plates of 350 mm x 16 mm and web plate of 1000 mm x 6 mm requires 

a) no stiffeners

b) vertical stiffeners

c) immediate vertical stiffeners ✔

d) vertical and horizontal stiffeners

Q.11. In a high flying aeroplane, the ink of the fountain pen leaks out because:

a) Atmospheric pressure increases

b) Atmospheric pressure reduces ✔

c) Atmospheric temperature increases

d) Atmospheric temperature reduces

Q.12. The capital of world youngest nation South Sudan is:

a) Juba ✔

b) Rumbek

c) Malakal

d) Wau

Q.13. In a code ‘Mumbai’ is written as ‘Sostpk’ and ‘Chennai’ is written as ‘dcfmmpk’, then “bench” will be written as:

a) m f m d c

b) t m f d c

c) t f m d c ✔

d) t f d m c

Q.14. How many triangles are there in the following figure?

a) 11

b) 13 ✔

c) 10

d) 09

Q.15. A hall 50 m long and 45 m broad is to be paved with square tiles. Find the largest tile as well as its number in the given options so that the tiles exactly fit in the hall?

a) 36 sq m and 80 tiles

b) 16 sq m and 80 tiles

c) 25 sq m and 90 tiles ✔

d) 36 sq m and 90 tiles